help me wire a dual 2 ohm to Sundown amp

[loud-n-low 10+ year member]

my sub is dual 2 ohm,paralleled to 1 ohm. do you get full 1 ohm power if you hook it to one set of speaker terminals on the amp? or do all terminals need to be connected? I searched

Click to read more...

 

[texicanz 10+ year member]

if its a mono amp it dont matter which terminal you use

 

[loud-n-low 10+ year member]

the Sundown manual shows both + being used and one - for a single sub setup so idk.

 

[texicanz 10+ year member]

what sub and amp model you have and if you have your subbwoofer wired like this then hook it your your amp like your bridgein it

http://www.the12volt.com/caraudio/woofer_configurations.asp?Q=1&I=22

 

[loud-n-low 10+ year member]

i know how to parallel the sub. my question is do i hook it up to only one set up speaker terminals on the Sundown, or do all need to be

 

[texicanz 10+ year member]

if its a class d amp then yeah you will be fine useing one speaker terminal

 

[loud-n-low 10+ year member]

ok. just didnt know why it showed all both sets of terminals used for a single sub setup

 

[J31Rob 5,000+ posts]

Just for ease of wiring. That is all.

 

[thorshammer1 10+ year member]

i know how to parallel the sub. my question is do i hook it up to only one set up speaker terminals on the Sundown, or do all need to be

I myself like to hook up both sets of speaker terminals. Its bridged internally so you can run 1 2ohm coil to ea terminal creating a 1 ohm load.

To answer the question though yes you can hook it up that way just fine.//content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

Yo OP where bouts in Upstate, NY are ya?