lostdaytomorrow
10+ year member
CarAudio.com Elite
I want to run the Nine.1 down to 1 ohm, so I need either Dual 4's or Dual 1's here.
My box is 2.6 cubes of airspace, tuned to 36 hz, 4" wide slot port, 43 sq. inches of port area (21.5 sq. in. of port area for each sub).
Right now I'm running some old W0's on a P2002 and it actually sounds hald decent for 200 watts in the trunk of a small car.
I just got the Nine.1 and I want to use all 1200 watts at 1 ohm.
I have 0/1 ran to a distro block in the back, and plan on using the old P2002 on my comps up front (haven't picked these out yet (6.5's)).
I'm looking at 30/70 SQ/SPL for this setup. Not loud and sloppy. But definitely loud and still tight.
I listen to rock, alternative, jazz, and rap at night driving around.
My price range for the two 10's is anywhere in the $400-$500 range. The problem I'm running into here is that I don't want to get some RE SX's that have 1000w rms each and only be giving them a little more than half ot that. Also, I'm going to be keeping my stock alt. for a while so don't really think I can go much bigger than the Nine.1 and the P2002 on it because that's already too much on my 90 amp alt. which means the Nine.1 most likely won't even be putting out 1200w @ 1 ohm but it's all good.
Cliffs: I need two new tens for a 2.6 cubes slot ported box. Running them @ 1 ohm off an eD Nine.1 (1200x1) 400-500 bucks. 70/30 SPL/SQ.
Thank you for your help.
My box is 2.6 cubes of airspace, tuned to 36 hz, 4" wide slot port, 43 sq. inches of port area (21.5 sq. in. of port area for each sub).
Right now I'm running some old W0's on a P2002 and it actually sounds hald decent for 200 watts in the trunk of a small car.
I just got the Nine.1 and I want to use all 1200 watts at 1 ohm.
I have 0/1 ran to a distro block in the back, and plan on using the old P2002 on my comps up front (haven't picked these out yet (6.5's)).
I'm looking at 30/70 SQ/SPL for this setup. Not loud and sloppy. But definitely loud and still tight.
I listen to rock, alternative, jazz, and rap at night driving around.
My price range for the two 10's is anywhere in the $400-$500 range. The problem I'm running into here is that I don't want to get some RE SX's that have 1000w rms each and only be giving them a little more than half ot that. Also, I'm going to be keeping my stock alt. for a while so don't really think I can go much bigger than the Nine.1 and the P2002 on it because that's already too much on my 90 amp alt. which means the Nine.1 most likely won't even be putting out 1200w @ 1 ohm but it's all good.
Cliffs: I need two new tens for a 2.6 cubes slot ported box. Running them @ 1 ohm off an eD Nine.1 (1200x1) 400-500 bucks. 70/30 SPL/SQ.
Thank you for your help.
