fuse help

  • 3
    Participant count
  • Participant list
depends on the wire. Welding cable or car audio cable aluminum or copper or copper tined aluminum. cause it could be a 250 fuse or a 300 . And with 2 runs of power wire your going to need 4 fuse holders. one at each end of the power wire and no more then 18 inches from the battery

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Question about the ground I have a small xs power battery. I know to run the 0 gauge to it then off that to the block. Do I have one spot for the...
16
2K
I made a lot of money repairing fuse boxes that were destroyed from people taping into them. Pay once by doing it right. Do it wrong, the second...
14
473
It would be cheaper, it might be easier to find a place to mount it, and you would have a ton of options if you just do two, 3 slot fuse holders...
4
638
My bad, yes, I read them each as having two 4ohm coils. The JBL diagram left a bit to be desired, IMO. ;) And a double yes, thought U was talking...
9
1K

About this thread

whitymanne

Junior Member
Thread starter
whitymanne
Joined
Location
fayetteville,nc
Start date
Participants
Who Replied
Replies
2
Views
456
Last reply date
Last reply from
1rockford1
Screenshot_20240531-022053.png

1aespinoza

    May 31, 2024
  • 0
  • 0
Screenshot_20240524_202505_Samsung Internet.jpg

winkychevelle

    May 24, 2024
  • 0
  • 0

New threads

Top