SOLD Forsale RD 10s and matching amp

dumple
5,000+ posts

What's in your trunk?
8,978
0
Philly
pictures first

will entertain trades now guys

img110.jpg
img111.jpg
img104-1.jpg
img100.jpg
amp1.jpg


sub specs

500 watts rms dual 4 ohm mounting depth i do not know it say 8 inchs or less

10" D4

FS

33.17 HZ

RE

3.4 OHM

QMS

5.23

QES

0.25

QTS

0.237

RMS

7.12

CMS

1.2899 MM/N

MMS

178.44 G

BL

22.6 TM

SPL@1W

87.23 DB

VAS

20.06 L

XMAX

13 MM

XCOIL

36 MM

amp specs

RMS power, 1 ohm mono 1050w x 1ch RMS power, 2 ohm mono 600w x 1ch Signal to Noise Ratio >100dB Low pass frequency crossover 35Hz~300Hz Subsonic filter 10Hz~60Hz Bass boost @ 45Hz 0~18dB Phase shift control 0~180 degree Frequency response 10Hz~350Hz (+/- 1dB) T.H.D @ 4 ohm

125 per sub

215 for the amp

pm me for more pictures or other inquires

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

As long as the subs are close to each other and the signal to is not Inverted on any subs, cancellation is not a big issue with sealed enclosures...
23
2K
Good explanation, thanks. I'll try installing that other amp soon. I have a stinger cap that shows my volts. It's reading 15v at max volume with...
17
2K
You can raise the back sea approx 2 inches and get a front firing enclosure for two tens in there ported center. Other than that. Atrend makes a...
5
1K

About this thread

dumple

5,000+ posts
What's in your trunk?
Thread starter
dumple
Joined
Location
Philly
Start date
Participants
Who Replied
Replies
81
Views
4,001
Last reply date
Last reply from
dumple
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top