fitting 0 gauge into smaller

[Tek18 10+ year member]

how do you fit 0 gauge into a smaller sized hole on an amp? i was told to get 0 gauge for my amp and people here can teach me how to make it fit >.

Click to read more...

 

[Kangaroux 5,000+ posts]

What amp? You can get 0g to 4g reducers to make it more "proper". Alternatively you can used a fused distro block from Knu to run it down to a 4g run to the amp (which is what I did for my audiopipe amp, worked great). Or you can simply trim down the wire

 

[Tek18 10+ year member]

this amp kit

Copper Clad Aluminum

and a soundstream rub1600

 

[Tek18 10+ year member]

this amp kit

http://www.knukonceptz.com/productDetail.cfm?prodID=KCA-PK0

and a soundstream rub1600

 

[Kangaroux 5,000+ posts]

Get 2 of these http://www.knukonceptz.com/productDetail.cfm?prodID=SSGR0

If they for some reason they are touching or very close when they are in the amp, wrap them in some electrical tape

 

[Tek18 10+ year member]

sounds good.

im also ordering some stuff for " big 3 " any suggestions? ( i can use those things you linked and order like 4 if needed. )

i was thinking Knukonceptz product detail for KCA KABLE 1/0 ULTRA FLEKS BLUE CCA POWER / GROUND CABLE

but with those things you linked it makes me re-consider

 

[Kangaroux 5,000+ posts]

Yeah just use the KCA for your big 3. Unless you plan on using the battery terminals that have holes in them, you shouldn't need any reducers.

 

[Tek18 10+ year member]

yea i was hoping for battery terminals with holes in them :S

 

[jj4475 10+ year member]

Just get the reducer things and enough wire to replace the stock wire.

 

[Kangaroux 5,000+ posts]

You can get the ones with holes in them it's not a big deal but I prefer the ones with just some bolts on the ends

 

[Tek18 10+ year member]

link^^?

 

[Kangaroux 5,000+ posts]

VIP sells them, NAPA probably does too. Check out my build log, search "kangaroux pathfinder"

 

[Dirtrider4eva 10+ year member]

just keep pushin', youll get it in.

..always worked for me anyways....

//content.invisioncic.com/y282845/emoticons/sneaky.gif.7189749b3a3f769e8815b47e8ae87f88.gif

 

[Dirtrider4eva 10+ year member]

just keep pushin', youll get it in.

..always worked for me anyways....

//content.invisioncic.com/y282845/emoticons/sneaky.gif.7189749b3a3f769e8815b47e8ae87f88.gif

 

[Imtjnotu 5,000+ posts]

Or u can shave a little bit off the 0 gauge