Expert opinions needed to help me buy a amp to power my subs.

[man_n_da_trunk 10+ year member]

Wussup everyone i need hlep buying a amp or amps to power my 4 alpine type xs. I had them powered by 2 hifonic brutis 2610s. The subs were wired to produce a 1ohm load. When i bought the amps the specs clearly stated that the amps were 1 ohm stable. That was a lie the amps lasted for about a week. Now im stuck with these beasts of subs and no amp to power them. Here are my thoughts. I was gonna buy 4 alpine mrp-m1000s and have each sub wired to 2ohms to get 1000 watts to each of them. But it has got to be an easier way. Then i seen a zrs c1 cadence amp monoblock 4500w sub classd amplifier. I could get two of these but ive never had cadence products before. Anyone that can tell me what amp can power these subs let me know. Here are the specs

i have 4 type xs, they are 4 ohms, the rms are 1000 watts just let me know what amp or amps that i can get to power these thanks for any advice anyone can giveView attachment 26522216

Click to read more...

 

[daboyfrumdabx 10+ year member]

What electrical upgrades do you have?

 

[man_n_da_trunk 10+ year member]

all my electrical has been completely upgraded to 0 gauge and the big three has been done. like i said my system was complete but my amps i guess were just over rated and when i put them to the test they didnt stand up to the power demand that these type xs need. so now im just looking for some amps to power them and wanted some expert opinions. i want these subs to get their full power

 

[-01limited- 10+ year member]

you needed more than the big 3 and 0 gauge to run two of them brutus's at 1 ohm a piece. A stock alt and no batteries cannot keep up with that.

 

[man_n_da_trunk 10+ year member]

when i say my system is complete it is complete minus the amps. i have the big 3 did in 0 gauge. two kinetik 2400 in the trunk one going to each amp. everything was done correctly those amps are just not made to handle that 1 ohm load. i dont care what anyone says i know from experience. but anyway thats not y i created this thread to talk about hifonic. anyone that has doubt about the way my system was hooked up check my build log it speaks for itself those amps just cant stand up to a 1 ohm load for long periods of time. now what i need from this thread is just amp sugestions if you cant give me any suggestions dont post

 

[05fronty 5,000+ posts]

when i say my system is complete it is complete minus the amps. i have the big 3 did in 0 gauge. two kinetik 2400 in the trunk one going to each amp. everything was done correctly those amps are just not made to handle that 1 ohm load. i dont care what anyone says i know from experience. but anyway thats not y i created this thread to talk about hifonic. anyone that has doubt about the way my system was hooked up check my build log it speaks for itself those amps just cant stand up to a 1 ohm load for long periods of time. now what i need from this thread is just amp sugestions if you cant give me any suggestions dont post

those amps can handle a 1 ohm load, i bet you fried the power supplies in them from too low of voltage

 

[-01limited- 10+ year member]

when i say my system is complete it is complete minus the amps. i have the big 3 did in 0 gauge. two kinetik 2400 in the trunk one going to each amp. everything was done correctly those amps are just not made to handle that 1 ohm load. i dont care what anyone says i know from experience. but anyway thats not y i created this thread to talk about hifonic. anyone that has doubt about the way my system was hooked up check my build log it speaks for itself those amps just cant stand up to a 1 ohm load for long periods of time. now what i need from this thread is just amp sugestions if you cant give me any suggestions dont post

whoa dawg, chill the fuck out or get the fuck out. :dont:Those amps can run at 1, but you just mentioned the big three and 0 gauge. I would of mention the two kinetiks in the back in there before even mentioning the big 3 or 0 gauge. Those two would be common sense if you would of mentioned the batteries, at least I'd hope so. But yeah, being new here, you'll get tons of people willing to help ya with an attitude like that. just my .02

 

[-01limited- 10+ year member]

those amps can handle a 1 ohm load, i bet you fried the power supplies in them from too low of voltage

lol, bastard. I took to long typing mine.

 

[-01limited- 10+ year member]

and anyways OP this is in the wrong section. We cant be dealing with dumbasses all day, but sadly we do.

 

[xoutofmyheadx 10+ year member]

well, when you look at the pic is there not 2 red kinetik batt in the pic as well? or am i just seeing things? call me crazy but looking at the pic that is in here may just have saved 7 out of the 8 posts.

 

[-01limited- 10+ year member]

well, when you look at the pic is there not 2 red kinetik batt in the pic as well? or am i just seeing things? call me crazy but looking at the pic that is in here may just have saved 7 out of the 8 posts.

its too small, didnt pay attention to it, just saw 4 subs. Kinda like when women don't pay attention to you because of your small dick.//content.invisioncic.com/y282845/emoticons/fyi.gif.9f1f679348da7204ce960cfc74bca8e0.gif

 

[xoutofmyheadx 10+ year member]

too small? you mean you haven't figured out to click on the pic to make it bigger? ..... really? and why are you worried about my **** size?

 

[-01limited- 10+ year member]

too small? you mean you haven't figured out to click on the pic to make it bigger? ..... really? and why are you worried about my **** size?

Naw meaning I dont give a fuck about the picture really. And I'm not worried bro, just figured you'd like some insight on whats wrong with your game

 

[xoutofmyheadx 10+ year member]

um... ok you can assume somethin is wrong with my game all you want. guess you need to make yourself feel better about being a moron and asking stupidazz questions. but w/e.

just curious OP, you strapped the amps together? just read through your build log and that's how i'm guessing you did it? unless i'm wrong here, if you strap amps together you can only go 2ohms. but in any case you still need a new amp.

 

[xoutofmyheadx 10+ year member]

that cadence amp is 800bux, hell for that money i'd get 1, 4500 sundown amp.