DIY 2 way components

I have a bunch of equipment in my garage and I am trying to put some of it to good use without spending a fortune on new gear, that being said I have a pair of fusion tweeters, a pair of Kicker Comp VR 6.5" woofers and some assorted crossovers (i pair fusion, 1 pair alphasonic) set as well as some higher end (but old) RF 2 way 6.5" s

I was wondering if any combination of these would even be worth hooking up in my front doors to replace the bose crap that came from the factory. I have an Infiniti G35x with the 7 speaker setup. The plan is to run the front and rears off of a pair of Memphis ST16-150's (again old, but I think they sound really good) I want to make the best use of my install time as I have a lot of work to do just to get this system up and running (factory amps and 2 ohm stock speakers, no drop in replacements)

Am I better off to just hook the tweeters to the same line (with inline filters) and run the 2 ways down low, or hook the X-over to the tweets and the woofers? Again just trying to use what i've got. I don't need perfect, just some improvement.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

werewolftigermo

Junior Member
Thread starter
werewolftigermo
Joined
Location
United States
Start date
Participants
Who Replied
Replies
0
Views
486
Last reply date
Last reply from
werewolftigermo
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top