Deadening Yo. Pictures!

[azbass 5,000+ posts]

//content.invisioncic.com/y282845/emoticons/woot.gif.aaa6090e619a97b6090d16dd863c5a69.gif pics

 

[kicker06 10+ year member]

does it make a difference if u cut it to small cuts or try to do a big peice.

Just make sure you overlap.

 

[kicker06 10+ year member]

I can already hear a difference, no more rattles in the door and the midbass response has increased. Good stuff. BTW, after 2 days of deadening, I am dead. IDK why, it's not that physical demanding, but I am tired. Maybe it's because I havent even slept 10 hours in the past 3 days =(

Pics:

Whole Door

Door Panel where speaker sits (Deadened More than this)

Once Again

Outter Skin

Yup

 

[Anthony Collova 10+ year member]

Nice install.

Glad to see it on a forum besides ours!

ANT

http://www.secondskinaudio.com

 

[CJL 10+ year member]

Did you notice any difference in the subs output after you deadened?

 

[kicker06 10+ year member]

Well my sub died the night I deadened.

So I am not sure. I got a few minutes of play the night I deadened, and there was no more rattles, but I really didn't get to listen. The next morning when I was going to school, the sub didn't work. There was no way I was overpowering the sub.

 

[bigbangtheory 5,000+ posts]

Well my sub died the night I deadened.
So I am not sure. I got a few minutes of play the night I deadened, and there was no more rattles, but I really didn't get to listen. The next morning when I was going to school, the sub didn't work. There was no way I was overpowering the sub.

That *****. //content.invisioncic.com/y282845/emoticons/crap.gif.7f4dd41e3e9b23fbd170a1ee6f65cecc.gif

Nice job on the deading. I need to get mine done, but way too cold here. I will probably wait till spring.

Also how much did all this cost you if you dont mind me asking. Just trying to get a ruff estimate.

 

[kicker06 10+ year member]

I got 100sq ft for $230 shipped. Not bad at all.

 

[tracyrick 10+ year member]

Curious why J3 is saying to leave some small holes for air to pass through? If nothing is living in your trunk, why is that needed?

 

[kicker06 10+ year member]

So the moisture can dry out, so there will be no rust.

 

[saltyreefguy 10+ year member]

very nice, so how much total would you say you use to do the entire car? were the rear doors done also?