DB8 10+ year member
Member
So I am pretty new here, found the site about 6 months ago, been addicted sense, I cannot stop reading.
The Car, 1994 GSR Sedan.
My Audio Setup:
HU: Kenwood DNX-7100
EQ: Clarion EQS744
3 Sets of Monster RCA's
Mid Amp: Diamond Audio D3 400.4
Fronts: Alpine TypeR 6.5" SPR-17S --- Factory Location (door panels)
Rears: Infinity 6x9" Reference --- Factory Location (rear deck)
Sub Amp: Diamond Audio D3 600.1
Subs: 2 - Eclipse 12" (unknown model)
1 Farad Cap
8g Alternator to Battery
4g Battery Ground
4g Run to Rear
4g T-Distribution Block
It sounds pretty good as is, in a sealed enclosure but I think I want to make the move to a ported, in a custom trunk setup.
I am open to advice, criticism (with advise), This was a budget system with less then 500$ spent.
Future plans, I am at least thinking of:
Install 6.5" in the rear deck (replace 6x9's) -- perhaps a Cut threw to allow more air flow.
Custom mount the EQ below the Screen (currently in glove box)
Mounting the tweeters in the mirror bolt covers
Thanks,
The Car, 1994 GSR Sedan.
My Audio Setup:
HU: Kenwood DNX-7100
EQ: Clarion EQS744
3 Sets of Monster RCA's
Mid Amp: Diamond Audio D3 400.4
Fronts: Alpine TypeR 6.5" SPR-17S --- Factory Location (door panels)
Rears: Infinity 6x9" Reference --- Factory Location (rear deck)
Sub Amp: Diamond Audio D3 600.1
Subs: 2 - Eclipse 12" (unknown model)
1 Farad Cap
8g Alternator to Battery
4g Battery Ground
4g Run to Rear
4g T-Distribution Block
It sounds pretty good as is, in a sealed enclosure but I think I want to make the move to a ported, in a custom trunk setup.
I am open to advice, criticism (with advise), This was a budget system with less then 500$ spent.
Future plans, I am at least thinking of:
Install 6.5" in the rear deck (replace 6x9's) -- perhaps a Cut threw to allow more air flow.
Custom mount the EQ below the Screen (currently in glove box)
Mounting the tweeters in the mirror bolt covers
Thanks,