CVS210RG-w6v2 wiring

[UTexasFight]

I need some help, i just bought the CVS210RG-W6v2 and i have some questions because it already comes in the enclosure. Is the sereies or parallel wiring already done inside of the enclosure, if so is there anyway i can change it without screwing anything up?

I hope this was the right place to post this message, sorr if it wasnt.

Thanks

Click to read more...

 

[bonesninja 5,000+ posts]

welcome to the forum but what is a cvs21org-w6v2?

 

[UTexasFight]

It is the 2 10' JL audio W6v2 subs in the JL enclosure.

 

[bonesninja 5,000+ posts]

oh well why didn't you say so in the first place? just kidding what type/model amp you plan on pushing them with?

 

[UTexasFight]

That is why i am asking... i want to know what amp to get and what specs it should have before i buy it so i need to know how the box is wired.

 

[bonesninja 5,000+ posts]

That is why i am asking... i want to know what amp to get and what specs it should have before i buy it so i need to know how the box is wired.

ok then. well my opinion is go for a viper 1200.1 wire the subs to parallel/parallel connection down to 1 ohm and there you go. or if you wanna stick with jl, get the 1000/1 and use a series/parallel connection to 4 ohms. it should not hurt anything to take the subs out to see the wiring scheme. those subs are dvc 4 ohms rated at 400w rms but real handling is more like 600w rms.

 

[UTexasFight]

so i do have the ability to change the wiring even though it's already in a box? it's not what you buy is what you get?

 

[bonesninja 5,000+ posts]

not at all my friend. just pop out the screws and rewire it as you like. hollar if you need any help or check this for wiring diagrams http://www.jlaudio.com/tutorials/wiring

 

[UTexasFight]

Thank you, your help is very much appreciated.

 

[bonesninja 5,000+ posts]

anytime.