I've never changed my blade in my table saw...I either use a rip blade or a finishing blade...Originally posted by Wkerat Do I need a special blade for my table saw to cut plexiglas?
Will that work for 3/4 in plexi?Originally posted by ricerdude i have cut plexi glass with a table saw and it worked very well...cut it like butter.... but if you are doing straight lines you put a metal ruler on the glass where you want the cut and run a sharp rasor blade along it a couple of times and then break it....that works.
That works up to 5mm or so...Originally posted by ricerdude i have cut plexi glass with a table saw and it worked very well...cut it like butter.... but if you are doing straight lines you put a metal ruler on the glass where you want the cut and run a sharp rasor blade along it a couple of times and then break it....that works.
If you have lots of blades marks from the blade of the jigsaw/bandsaw, next time try a fine file to remove them first, then take the sandpaper(180-220 grit) and it will polish things right up.Originally posted by paikiah what I did was cut it with a jig, then sand the plexi slowly with a fine sandpaper...
It cuts like nothing.Is it hard to cut with a table saw?