comp install help.

[tacovic 10+ year member]

ok so i am a noob to the whole component speaker game but not to car audio. i know all about wiring up subs and mono block amps but not 4 channel amps with speakers and tweets. ok first off this is the equiptment i have to work with.

http://www.reaudio.com/components.html the base model one

http://www.cadencestore.com/ProductCart/pc/viewPrd.asp?idcategory=125&idproduct=383 and this amp.

i can figure out how to bridge it to 2 channels but how do i get the ohm load for the speakers? and tweets? i have no clue how to wire this up. if anyone could help me out i would greatly appreciate it.

this is going into a 06 civic lx sedan.

or if anyone is near the twin cities MN and is willing to help me out for a little cash let me know

Click to read more...

 

[lyttleviet 10+ year member]

you plug the tweet into the xover, the mid into the xover, take the lead out for each xover and plug it into the pos of one side and the neg of the other side. Take the other side (passenger) and do the same and bridge the "rear" channels the same way... If I wasn't busy I'd draw you a picture.

I am sure you can find a picture if you search a bit

 

[tacovic 10+ year member]

ok i think i got the wiring part..

but what do i need to set the settings on the amp on.

 

[tacovic 10+ year member]

bump