combine 2 subs

[GRANDPA 10+ year member]

i have 2 12 inch subs and a 2 channel amp. i want to combine the 2 subs so the max wattage for the subs will be 1200 watts. any suggestions?

Click to read more...

 

[jpexpc 10+ year member]

You need to be more specific. What subs? What amp? Are you asking how to wire them for maximum output or if you should get something different? Again, be more specific.

 

[csu87 10+ year member]

wire the subs together and bridge the amp. check out rockfordfosgate.com or crutchfield.com. they both have wiring diagrams

 

[jpexpc 10+ year member]

wire the subs together and bridge the amp. check out rockfordfosgate.com or crutchfield.com. they both have wiring diagrams

Do this if you don't like your equipment and want an excuse to buy better stuff.

 

[pr-festiva 10+ year member]

lol

 

[GRANDPA 10+ year member]

You need to be more specific. What subs? What amp? Are you asking how to wire them for maximum output or if you should get something different? Again, be more specific.

the 2 mtx terminators and a crunch 1100 watt amp. n i am asking how to wire them for maximum output.

 

[csu87 10+ year member]

well youre not going to get 1200 out of that amp. what ohm are your subs

 

[GRANDPA 10+ year member]

well youre not going to get 1200 out of that amp. what ohm are your subs

4 ohm

 

[csu87 10+ year member]

and specs on amp. there are quite a few crunch out there

 

[stangman67 10+ year member]

single or dual 4? If they are single you need to wire one sub to each channel then. It won't be 2 ohm stable bridged

 

[jpexpc 10+ year member]

If they are SVC 4 ohm you should just wire 1 sub to each channel. I doubt your amp is 2 ohm stable bridged so I wouldn't do this. Again, the guy that told you to bridge them is wrong.

 

[GRANDPA 10+ year member]

and specs on amp. there are quite a few crunch out there

its a 1100 watt crunch powerzone amp 2 channel bridgeable

 

[jpexpc 10+ year member]

its a 1100 watt crunch powerzone amp 2 channel bridgeable

http://www.brilliant-electronics.com/car_amplifiers_crunch_p1100.2.htm

You can only bridge it at 4 ohms. 1 sub per channel.

 

[csu87 10+ year member]

If they are SVC 4 ohm you should just wire 1 sub to each channel. I doubt you're amp is 2 ohm stable bridged so I wouldn't do this. Again, the guy that told you to bridge them is wrong.

didnt know his amp or subs. i was just saying it was a possibility.

its a 1100 watt crunch powerzone amp 2 channel bridgeable

your only getting 550 peak per channel. I have a JBL BP1200.1 i will sell you that will easily power those subs