Chevy Malibooty build log lol 12" setup

It was a b*tch to put the deadener in lol. Consisted of fine razor cuts on my finger tips, rubber in my wounds/all over my arms, sweat, and about a little over an hour to do just the trunk lid. It was fairly easy but boring and very time consuming. Worth it though!

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I had a '99 Chevy Venture with the 3.8 and buddy had one with the 3.4. Any of those engines including the 3.9 are known to leak coolant at the...
12
747
You can raise the back sea approx 2 inches and get a front firing enclosure for two tens in there ported center. Other than that. Atrend makes a...
5
1K
A lot of guys say I'm going low-end on cost but I see a lot of guys recommending just as cheap or cheaper products. Like MESO-6-5-3WAY-COM //...
13
2K
I would add two more of the same subs and look at selling the 2k to go towards the funds of a decent 5-8k mono amplifier and new enclosure
3
1K

About this thread

solidcrowd

10+ year member
CarAudio.com Elite
Thread starter
solidcrowd
Joined
Location
Buffalo, New York
Start date
Participants
Who Replied
Replies
18
Views
2,915
Last reply date
Last reply from
bigbangtheory
Buick Amp Connector.JPG

maylar

    Jun 2, 2024
  • 0
  • 0
1717274743729.png

Doxquzme

    Jun 1, 2024
  • 0
  • 0

New threads

Top