Can i wire 2 sets of components to a 2 channel amp?

[csb41502 10+ year member]

I just picked up 2 sets of cadence 6.5 components for my front and rear doors. Im working on a budget right now and only have a brand new soundstream 250 watt 2 channel amp. Is there a way i can make this work?

Click to read more...

 

[sjv13 10+ year member]

yes there is. But whether or not it is possible depends on your amp's ability run at the right number of ohms while at a decent RMS level.

 

[csb41502 10+ year member]

I know the amp is 125x2 at 2 ohms

 

[maylar 10+ year member]

You can put front and rear seaker to a single channel - that gives you 2 ohms. You'd lose the ability to fade front / rear but if it's temporary until you get another 2 channels you might be OK with it. Or run the rear set off the HU and only amp the fronts.

 

[calebkhill 10+ year member]

So adding two sets of 4ohm drivers to a single channel does bring the impedance down to 2 ohms?

 

[maylar 10+ year member]

Yes.