Can I run dual DVC's at 2 Ohm?

Well, that depends on the impedence of each voice coil. By looking on the CDT site, it appears as though each coil is 4ohm......which would mean no, you can't get a 2ohm load with two of these subs.

 
your not going to hear any difference in hooking only one coil up verses two.
You're joking right?? Because only using one VC changes every T/S parameter, box requirements, motor strength is cut in half (only have half of the reacting force), etc etc etc. Not something smart for the average person to do.

 
You're joking right?? Because only using one VC changes every T/S parameter, box requirements, motor strength is cut in half (only have half of the reacting force), etc etc etc. Not something smart for the average person to do.
Power handling is cut in half too.

 
but you can wire to 1-ohm //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif//content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

DarrenE46

10+ year member
Senior VIP Member
Thread starter
DarrenE46
Joined
Location
Orlando, FL
Start date
Participants
Who Replied
Replies
9
Views
694
Last reply date
Last reply from
MisterE
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top