brain fart

[CHEMMINS 10+ year member]

I already gave him that buck.....look a few posts up....lol.

 

[Buck 5,000+ posts]

I already gave him that buck.....look a few posts up....lol.

Oh, well I applaud you sir.

 

[VWBobby 10+ year member]

I've been around car audio for about 12 years, and I never noticed the difference between 4 ohms on a SVC or 4 ohms on a DVC.

Apparently a lot of other people in this thread didn't either!

For the smartasses in this thread... Why is it 1.34 ohm on a SVC compared to 2.67 on a DVC, both wired to 4 ohms per sub?

 

[CHEMMINS 10+ year member]

I've been around car audio for about 12 years, and I never noticed the difference between 4 ohms on a SVC or 4 ohms on a DVC.Apparently a lot of other people in this thread didn't either!

For the smartasses in this thread... Why is it 1.34 ohm on a SVC compared to 2.67 on a DVC, both wired to 4 ohms per sub?

Cause you can't wire a dual 4 into 4 ohms on a sub...it is either 2 or 8.

But then again, I am not a dumass and I haven't been wiring subs for 12 years.....13 maybe but not 12. I did notice a difference between 4 ohms on a svc vs a dvc.....the dvc had 2 - 4 ohm coils.

 

[Buck 5,000+ posts]

Because if you were to compare a DVC 4 to a SVC 4, it'd be like comparing either a SVC 2 or 8 to a SVC 4....if that makes sense.

 

[Vossy 10+ year member]

That 2500d will handle .5 all day.

 

[PIITB Wut Wut 10+ year member]

wow this thread.....

 

[CHEMMINS 10+ year member]

Incredible eh?

 

[stangman67 10+ year member]

There is a ton of fail going on in here.

 

[VWBobby 10+ year member]

Cause you can't wire a dual 4 into 4 ohms on a sub...it is either 2 or 8.
But then again, I am not a dumass and I haven't been wiring subs for 12 years.....13 maybe but not 12. I did notice a difference between 4 ohms on a svc vs a dvc.....the dvc had 2 - 4 ohm coils.

I'm talking about wiring the subs in series-series..... not series-parallel like the diagrams/calculators show.

You would have half the load wired in true series.

I'm not talking about typical subs that give you 2 wiring options......2 or 8 ohms.//content.invisioncic.com/y282845/emoticons/wow.gif.23d729408e9177caa2a0ed6a2ba6588e.gif

 

[FenixAudio 10+ year member]

in series u add the resistors u cant drop ohms unless u wire them in parallel at some point