Box question?

  • 6
    Participant count
  • Participant list
I'm a ported enclosure fan, you get more output from the sub most of the time "sub dependent" , with a ported enclosure then with a sealed. and more lower end frequency response as well. and you don't need as much power to push them.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I'm trying to do 4 18 inch resilient sound platinums in a cpillar flat wall .4 to 5 cubes per was told they like 12 to 16 inches per cube . I have...
0
1K
Yeah I'm in a circle right now too. I'm going to use 3/4" birch so I don't want to build it twice, stuff ain't cheap.
5
2K
Emphasis added. The answer is, because you can also see DCR at other frequencies and because low impedance is extremely torturous on...
9
2K
Common chambered sealed or ported is fine. Just make sure you have sufficient bracing
1
1K
Start by laying the larger bottom panel in an open space, then slowly “dry” assemble it by laying the pieces where they go like a puzzle. It...
1
304

About this thread

Chevy Boy

10+ year member
Member
Thread starter
Chevy Boy
Joined
Location
Greenville, NC
Start date
Participants
Who Replied
Replies
5
Views
360
Last reply date
Last reply from
PowerNaudio
all out.jpg

Popwarhomie

    Jun 2, 2024
  • 0
  • 0
all out.jpg

Popwarhomie

    Jun 2, 2024
  • 0
  • 0

New threads

Top