box help

[gerardc 10+ year member]

i am making a 3 sided box so i can faber the top. the bottom is fat at one end and then becomes smaller as it goes back. how do i put sides on it? the side would have to curve as well. how do you make a board curve?

Not good at making 2D into 3D

Click to read more...

 

[Trixter 10+ year member]

a little hard to vision what your talkin with out a pic...sorry.

 

[gerardc 10+ year member]

If you look at a new 05' dodge dakota you can see that the center console plastic and i am making one out of 1/2 mdf but i can't get how to make it curve as well. I am just trying to make the same console just out of mdf.

Copy the URL and look at the center console. It has a cup holder at the front that I would like to keep but i need to frame the sides so i can fiber the inside up to the top of the hill of the console. the flat part of the console that holds the heater buttons and other large cup holder I would like to put a ipod dock in between them both flat. //content.invisioncic.com/y282845/emoticons/veryhappy.gif.fec4fed33b4a1279cf10bdd45a039dae.gif

 

in the back i will have two 8in subs coming off the back. and i would like to fiber it all so i can make it all one piece.

http://www.caraudio.com/forum/attachment.php?attachmentid=6014&stc=1&d=1159371366

http://www.caraudio.com/forum/attachment.php?attachmentid=6015&stc=1&d=1159371427

http://www.caraudio.com/forum/attachment.php?attachmentid=6016&stc=1&d=1159371925

This is what my cab looks like and it will have two 8in swallow subs add to the console to fit between the back seats.

http://www.caraudio.com/forum/attachment.php?attachmentid=6017&stc=1&d=1159372142