Box build for 2 customers **PICS**

I havent put in the screws yet for the plexi though. When I do its gonna really set it off //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 
You need to paint the inside of the box w/plexi.
That is true. But was not requested. The box is for his wife and he is painting the magnets pink so all you will see is pink magnets anyway.

 
finished pics:

30kzndt.jpg


5brc42.jpg


ousf1y.jpg


 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I think you're gonna have to get good with fiberglass or something, or find someone with a 3d laser scanner that can 3d print or mold you some...
7
1K
The tricky bit is that they're soft and floppy and they may be stretched a tad to go over the frames. I've used them in the past and come out...
6
2K
In order to answer your question, I would need to know what model (e.g. SW4200, SW7524DVC). Also, are you looking to make a ported box or sealed?
3
2K
Thanks everyone for the feedback. I got scared of the 4th being to much for a newbie but did end up building a box to 2.1 Cubic Foot tuned to...
7
2K
Love this sub, hate AB's site, short on info for sure. American Bass XR-10D2 box recomend: If you want to tune a 2.75 Cu Ft box (for two of these...
11
3K

About this thread

bassman3

10+ year member
Box Designer & Fabricator
Thread starter
bassman3
Joined
Location
Oregon
Start date
Participants
Who Replied
Replies
25
Views
2,376
Last reply date
Last reply from
bassman3
all out.jpg

Popwarhomie

    Jun 2, 2024
  • 0
  • 0
all out.jpg

Popwarhomie

    Jun 2, 2024
  • 0
  • 0

New threads

Top