Better: Eclipse SW9122 or Eclipse SW8200 ?

[dragnix 5,000+ posts]

3 cu sealed would be nice for a pair of 8200's. I had mine in a 1 cube, and it had a peak in the response curve, with little low end (LOW low end).
increasing to 1.5 each would prob be very nice //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

doesn't the 8200 use the LMT coils? If so, those things require huge *** boxes. I was given the recommendation of 3cu. sealed each

 

[ultimate157 5,000+ posts]

doesn't the 8200 use the LMT coils? If so, those things require huge *** boxes. I was given the recommendation of 3cu. sealed each

Yes, it uses the LMT. I also tried it in a 4.2 sealed for a .707 alignment. It reinforced the low end so ridiculously it had no balls above 40hz. Flexed the roof 1" at 20hz for a single 12" //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

 

[dragnix 5,000+ posts]

ah, true HT sub

 

[ultimate157 5,000+ posts]

ah, true HT sub

Which is where its going to be used next. Can't wait //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[dragnix 5,000+ posts]

nice, i got rid of both of mine //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif

To the OP, go with the 9122, it's better for in car IMHO. And it gets louder too //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif