hone
Member
I have 2 DD amps that went into protect mode today. DD M3C & SS4A. I think the amps are good and so is the RCAs for the M3C.
I determined this by unplugging all RCAs, both amps got the green light. Then I tried just the M3C RCAs and again both amps power up and I have bass.
Then I tried just the SS4A RCAs(JL audio 4 channel, not premium). I get a couple of pops and protect mode.
Then I tried both amps together and the m3c protects as well. So it seems the m3c will work on its own but not when the 4 channel amp is also connected.
This setup has been working fine for about a month and suddenly went out. Any advice would be appreciated.
Sent from my GT-N5110 using Tapatalk
I determined this by unplugging all RCAs, both amps got the green light. Then I tried just the M3C RCAs and again both amps power up and I have bass.
Then I tried just the SS4A RCAs(JL audio 4 channel, not premium). I get a couple of pops and protect mode.
Then I tried both amps together and the m3c protects as well. So it seems the m3c will work on its own but not when the 4 channel amp is also connected.
This setup has been working fine for about a month and suddenly went out. Any advice would be appreciated.
Sent from my GT-N5110 using Tapatalk