Amp wire size advice

  • 2
    Participant count
  • Participant list

Ralleygreen

Junior Member
Hello, I'm adding an amp need advice on my wire size. My new set up jl audio jx360/4 bridged to 2 subs jl10wx 4 ohm, front amp jx360/2 with jlc3-650s in the doors I already have an ofc 4 gauge wire is it ok to bring in another 4 gauge wire for the new amp. It will be more exspensive for me to buy 2 gauge wire then split to two 4 gauge wire thanks .... Mike

 
It's ~720w. Why two 4 awg?

A 4 split to 8's would be more than adequate.

If you prefer for some reason to do two 4's there's certainly no problem with it.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Agreed. I've used some very fine cable for +REM connections because I had it laying around and have had issues with it failing. Good quality...
5
2K
yeah, it'll be hot but off. Just like your tv when it's plugged in.
3
1K
If you have multiple amps you do not need to run a power wire from each amp to battery.. You can have a single run of wire with a distribution...
1
1K
EMR sniffer or AM/FM sniffer. small radio but with a probe antenna to it. It gives you the specific location on the ground loops. This device...
26
3K

About this thread

Ralleygreen

Junior Member
Thread starter
Ralleygreen
Joined
Location
Fairlawn NJ
Start date
Participants
Who Replied
Replies
2
Views
427
Last reply date
Last reply from
Ralleygreen
1717274743729.png

Doxquzme

    Jun 1, 2024
  • 0
  • 0
Screenshot_20240531-022053.png

1aespinoza

    May 31, 2024
  • 0
  • 0

New threads

Top