Amp help

  • 4
    Participant count
  • Participant list

PNILLZ

Junior Member
I have a db drive dual 600w max sub box and an okur 1000.1 amp, I have had this same setup for about 2.5 years. Recently the amp had been going into protection mode I checked all the wires, fuses, connections, and for corrosion, but it kept going to protect. I played the amp by itself for a few days and it was fine. Then I connected the subs back and it fucked up again, then I just connected one sub and its been playing fine. Does anyone know what the problem could be?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Using Sky High copper OFC wiring and Stinger 8000 series rcas. The US Acoustics usx4085 is rated at 85X4 @ 12.9 volts and proably close to 100w X...
6
232
This may be an option for you as well. Im sure Amazon has them on theyre site also to be purchased. Great amps...
11
1K
Yeah, put the probes on the power wire and ground wire of the amplifier. Multimeter on DC. Do not put it on the wires that go to your speakers. M
6
700

About this thread

PNILLZ

Junior Member
Thread starter
PNILLZ
Joined
Location
New Jersey
Start date
Participants
Who Replied
Replies
5
Views
823
Last reply date
Last reply from
Side Show
Screenshot 2024-05-31 182935.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0
Screenshot 2024-05-31 182324.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0

New threads

Top