Amp for 4 12" MTX 8000?

[gamr17 10+ year member]

Just bought 4 12" MTX 8000 that run at 1000 peak at 4-ohm. Whats the best amp for these subs, and also was a low cost amp that will get me by pretty good for now??

Click to read more...

 

[RangerMan Premium Member]

I would recomend getting the MTX 81000D amp for your subs. It is a very reliable amp and relativery low cost. You might want to get two of them. They are pretty cheap on ebay, they go for around $375.

 

[Unregistered]

whats the specs on that amp?

 

[RangerMan Premium Member]

They are like 1500 watt amps. Check it out on ebay.

 

[Unregistered]

i have an ma audio hc4002 i want 500 for it and it is 4000 watts rms.

 

[chrisradiogod]

wrong answer!!!!!!!!!!!!!it wont run 4 4ohm subs. they have to be 8 ohm

 

[caraudiogod 10+ year member]

Good call Chris. If you are going to run with a T8100D. Then you are going to need two of them to run all four subs. That amp is only suppose to handle 2 four ohm subs. But that'll definately pound!!! If you want a cheaper way out. Go with two MTX T6500Ds. That'll work too. And if you need a good price on em...drop me an email...bobby_solis@hotmail.com

 

[RangerMan Premium Member]

Hey dude I said he might want to get two of them. Don't tell me I have the wrong answer until you read the whole post.

 

[audiolife 5,000+ posts]

try a harrison sound labs (gain tuning a must meaning touchier than normal) or memhis studio class d or crossfire class d

 

[m83x 10+ year member]

RangerMan's right... he did said two..

 

[RangerMan Premium Member]

Where ya at Mr. Know It All?

 

[Phatillusion 5,000+ posts]

He's at school. Taking reading lessons

 

[RangerMan Premium Member]

Probably so...//content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[Uhalfdirty]

a look get u 2 bout 1000 watt amp and it will push the hell out of that shit! hola at yo boy form atl!

 

[Unregistered]

IF im not mistaken you can make 4 four ohm 12,s run a four ohm load by running them all in series. Or you can run two sets in series to run a two ohm load. _-o+_-o+_-o+_-o+_ the lower slashes represent the wire. This should be a four ohm load. With 4 four ohm drivers. _-o+_-o+_ / _-o+_-o+_ this would be a 2ohm load with 4 4ohm drivers to a mono channel.Good luck.