Aftermarket speaker setups in a CRX

[williambrea 10+ year member]

Just wondering what people have done for speakers in a CRX. I was thinking about just one component set and be done, but am i going to need a rear fill or is the car small enough that it does not matter?

Click to read more...

 

[MSW Danny 10+ year member]

do you plan on having a substage?

 

[williambrea 10+ year member]

yea 9512 and saz-3000

 

[MSW Danny 10+ year member]

in that case, i would just go with the comps in the front and ditch the rear.

 

[williambrea 10+ year member]

anybodies?

also, what about Coax all around?

 

[groundpound4200 5,000+ posts]

components up front only...

 

[lyttleviet 10+ year member]

depending on your budget for components up front + amp, if its not a "higher end" component set with good power, you might want to get rearfill. That sub is going to be real loud with all that power and something mediocre won't cut it.

 

[audiolife 5,000+ posts]

compression horns and a 6" in the kick or if you must the door.

http://www.imagedynamicsusa.com/products.php?Family_Id=5&Product_Id=23

 

[Louisiana_CRX 5,000+ posts]

I have DD midbass in my front doors but I had to use a spacer to make them fit.....I may try something different because I'm probally gonna move those to my Xtreme Blazer front doors...I have a set of RSD mid bass I may see if will fit behind the stock grills...right now the stock grills are off the car...on each corner of the dash I have a set of Earthquake Screamer mid tweeters...they are really nice...I am running an active setup for now...

 

[bigaudiofanatic 10+ year member]

Use LOTS AND LOTS fo dynomat in the rear it sounds like a tin can most of the time.

 

[SPL140.2 5,000+ posts]

Use LOTS AND LOTS fo dynomat in the rear it sounds like a tin can most of the time.

especially if you have a catback it gets pretty noisy. //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[DBDRAGGUY 10+ year member]

I glassed over the plastic grills and cut holes for a set of 4" crystal components. Not much will fit in the doors without a spacer or buildout of some sort.