amena
Junior Member
I know that most people use 1/0 but i have some 1 gauge that i was thinking about using for power for my earthquake phd2. currently it is hooked up with a 4 gauge but i am only running 2 rf hx2's, i am taking that out and am going to install it into my other car, but i am going to use 4 rf hx2's. Has anyone ever used a 1 guage instead of a 1/0? They are about the same sizes so i figured i can use a 200 amp anl fuse for 1/0.
Second question, for my subs i am using 8 guage for all four, but my amp only has an opening for 1 8 gauge. I have been trying to figure out how i can fit all four 8's for the positive and all four 8's for the negative. i was thinking of getting a scotch lock and running all four 8's in with an additional 8 as a pigtail. does anyone have any other ideas. the reason i am doing this is because all 4 subs are dual 4 ohm, so i am wiring them to 8 ohm, and then running all of the positives and negatives together to get a 2 ohm load. any help would be appreciated.
attached is a picture of how i am wiring it, curtesy of rockford fosgate.
Second question, for my subs i am using 8 guage for all four, but my amp only has an opening for 1 8 gauge. I have been trying to figure out how i can fit all four 8's for the positive and all four 8's for the negative. i was thinking of getting a scotch lock and running all four 8's in with an additional 8 as a pigtail. does anyone have any other ideas. the reason i am doing this is because all 4 subs are dual 4 ohm, so i am wiring them to 8 ohm, and then running all of the positives and negatives together to get a 2 ohm load. any help would be appreciated.
attached is a picture of how i am wiring it, curtesy of rockford fosgate.