500-700w @ 2ohm

ctmike
10+ year member

CarAudio.com Elite
Rating: 0%
0 0 0
Looking for amp that'll go with my w6, and not looking to spend a lot. Had another thread for this but not seeing it, so post what you have for sale. Not looking for garbage brands neither, but decent amps that'll do rated+. Would love to find a pg xenon 600 or sundown sae 1000d

 
I have an Xtant a6001 ...told it has balls @ 2ohm..unfortunately I have 2 subs that neither do 2ohm. $125 shipped. got it from my electronic engineer buddy

Specs:Frequency Response: 20 Hz to 120 Hz +/– 1 dB

Number of Channels: 1

Watts per Channel @ 4Ω: 1 x 300

Watts per Channel @ 2Ω: 1 x 600

Recommended Load: ≥2Ω

Distortion (THD): ≤2%

Measured: 20 Hz to 120 Hz at rated power, all channels driven 4Ω

Signal to Noise Ratio: ≥ 100 dB

Measured: A-weighted in 20 kHz noise bandwidth @ 1 volt sensitivity

Damping Factor: ≥ 100 @ 100 Hz with 4Ω load

Input Sensitivity: 100 mV to 8.5 V RMS Unbalanced

200 mV to 17 V RMS Balanced

Input to Line Output Gain: 0 dB

On-Board Crossover: 24 dB/Octave Low Pass

Balanced Line: On Board

Power Supply: Fully Regulated, PWM

Operational Voltage: 10 to 16 Volts

Fusing Requirement: 40 Amp

Size (L xW x H): 11-5/8” x 9-1/4” x 1-7/8”

295mm x 235mm x 47mm

Subsonic Filter: 24 dB/Octave 20-80 Hz

Bass Boost: 0-12 dB @ 45 Hz

 
Last edited by a moderator:
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

ctmike

10+ year member
CarAudio.com Elite
Thread starter
ctmike
Joined
Location
ct.
Start date
Participants
Who Replied
Replies
13
Views
914
Last reply date
Last reply from
gentlejax
IMG_0710.png

michigan born

    May 14, 2026
  • 0
  • 0
IMG_0709.png

michigan born

    May 14, 2026
  • 0
  • 0

New threads

Top