Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
CarAudio.com Classifieds
Car Audio Wanted
500-700w @ 2ohm
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="gentlejax" data-source="post: 7811863" data-attributes="member: 548376"><p>I have an Xtant a6001 ...told it has balls @ 2ohm..unfortunately I have 2 subs that neither do 2ohm. $125 shipped. got it from my electronic engineer buddy</p><p></p><p>Specs:Frequency Response: 20 Hz to 120 Hz +/– 1 dB</p><p></p><p>Number of Channels: 1</p><p></p><p>Watts per Channel @ 4Ω: 1 x 300</p><p></p><p>Watts per Channel @ 2Ω: 1 x 600</p><p></p><p>Recommended Load: ≥2Ω</p><p></p><p>Distortion (THD): ≤2%</p><p></p><p>Measured: 20 Hz to 120 Hz at rated power, all channels driven 4Ω</p><p></p><p>Signal to Noise Ratio: ≥ 100 dB</p><p></p><p>Measured: A-weighted in 20 kHz noise bandwidth @ 1 volt sensitivity</p><p></p><p>Damping Factor: ≥ 100 @ 100 Hz with 4Ω load</p><p></p><p>Input Sensitivity: 100 mV to 8.5 V RMS Unbalanced</p><p></p><p>200 mV to 17 V RMS Balanced</p><p></p><p>Input to Line Output Gain: 0 dB</p><p></p><p>On-Board Crossover: 24 dB/Octave Low Pass</p><p></p><p>Balanced Line: On Board</p><p></p><p>Power Supply: Fully Regulated, PWM</p><p></p><p>Operational Voltage: 10 to 16 Volts</p><p></p><p>Fusing Requirement: 40 Amp</p><p></p><p>Size (L xW x H): 11-5/8” x 9-1/4” x 1-7/8”</p><p></p><p>295mm x 235mm x 47mm</p><p></p><p>Subsonic Filter: 24 dB/Octave 20-80 Hz</p><p></p><p>Bass Boost: 0-12 dB @ 45 Hz</p></blockquote><p></p>
[QUOTE="gentlejax, post: 7811863, member: 548376"] I have an Xtant a6001 ...told it has balls @ 2ohm..unfortunately I have 2 subs that neither do 2ohm. $125 shipped. got it from my electronic engineer buddy Specs:Frequency Response: 20 Hz to 120 Hz +/– 1 dB Number of Channels: 1 Watts per Channel @ 4Ω: 1 x 300 Watts per Channel @ 2Ω: 1 x 600 Recommended Load: ≥2Ω Distortion (THD): ≤2% Measured: 20 Hz to 120 Hz at rated power, all channels driven 4Ω Signal to Noise Ratio: ≥ 100 dB Measured: A-weighted in 20 kHz noise bandwidth @ 1 volt sensitivity Damping Factor: ≥ 100 @ 100 Hz with 4Ω load Input Sensitivity: 100 mV to 8.5 V RMS Unbalanced 200 mV to 17 V RMS Balanced Input to Line Output Gain: 0 dB On-Board Crossover: 24 dB/Octave Low Pass Balanced Line: On Board Power Supply: Fully Regulated, PWM Operational Voltage: 10 to 16 Volts Fusing Requirement: 40 Amp Size (L xW x H): 11-5/8” x 9-1/4” x 1-7/8” 295mm x 235mm x 47mm Subsonic Filter: 24 dB/Octave 20-80 Hz Bass Boost: 0-12 dB @ 45 Hz [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
CarAudio.com Classifieds
Car Audio Wanted
500-700w @ 2ohm
Top
Menu
Home
Refresh