5 channel amp and 6 speakers plus sub?

[bbroge]

Ok, so I have the following:

Infinity Kappa Five Amp

Kappa 693.9i 6x9 Speaker Pair (2ohm impedance)

Kappa 462.9cfp 4x6 Pair (2ohm impedance)

Kappa 6-1/2" 3-way Speaker Pair (2ohm impedance)

Right now I basically have the amp in a standard 5 channel operation:

Two 6x9 speakers are connected to rear amp channel, sub is connected to sub channel, and the 6x9 are connected to front channel.

Can I safely connect the two 4x6 speakers to the same channel my 6 1/2 are connected to at the same time?

I found this in my amp manual-

Minimum speaker impedance for stereo operation is

2 ohms. Minimum speaker impedance for bridged

operation is 4 ohms. Minimum subwoofer impedance

is 2 ohms.

So if I connect the 4x6 in series it would equal 4 ohms I believe or would I need to connect them in parallel? I think I can just connect them in a series, I just would like to verify that is Ok before I do anything.

Thank you!

Click to read more...

 

[fasfocus00 5,000+ posts]

what car? are your 4x6s, 6.5s, and 6x9 all factory locations?

 

[bbroge]

what car? are your 4x6s, 6.5s, and 6x9 all factory locations?

These speakers are installed in a 2002 Chevy Blazer, all factory locations.

 

[joelp88]

Yes, in series you would have a 4 ohm load.