350z build

Well, unless i build some type of amprack behind the strut bar i will need to cover the entire enclosure so the back wont be bare mdf. I always wondered if the Z would be easy to run wires thru. I ordered some of the new 0ga Flekz wire from Knu Should be here 2morrow.

 
the hardest part about running wires is running the power wire, and even that was simple //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

it might have been a little easier for me though, i didnt have to run any RCA cables //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 
Looks good. Love the lemans color.i going to finish my audio then I will be getting my set of wheels finnally a set of 19" Volk GTS in RMC finish //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif Time for some agressive *** offsets and a nice drop

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

mr_kebo

10+ year member
CarAudio.com Elite
Thread starter
mr_kebo
Joined
Location
Huntsville, AL
Start date
Participants
Who Replied
Replies
25
Views
1,835
Last reply date
Last reply from
mr_kebo
1778578257023.png

Glen Rodgers

    May 12, 2026
  • 0
  • 0
Screenshot_20260511_212804_Amazon Shopping.jpg

Blackout67

    May 11, 2026
  • 0
  • 0

New threads

Top