Here's the pic of my fiberglass drying....I have sooo many bubbles but i couldnt get them to go away.. Should i like dremel them off before adding more layers to it??
Another angle..
Here's a picture of the work area....notice the fan in the car blowing all the rank fumes away so my car never smelt bad //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif
Here's the mold popped....I couldnt disconnect the mold from the foil/duct tape very easily but since blue painters tape is wussy as hell i was just able to pop it all off. Took a total of 2 minutes.
another...
and another....
And here's a picture of the sub ring i made while waiting for the fiberglass to dry... it's not superb but doesnt need to be if its goin under my carpet anwyay. Used a jigsaw to cut since i dont have that circle cutter tool for the dremel.
And lastly here's a picture of it in the trunk ready for some more layers
So anyways, project isnt goin too bad so far. Havent hit any problems except for the bubbles, and im hoping someone says its a good idea to dremel em off cause that wouldnt be hard at all i dont think.
What's the best type of fleece to use to cover my sub ring when i put it in place
Thanks for lookin.
Another angle..
Here's a picture of the work area....notice the fan in the car blowing all the rank fumes away so my car never smelt bad //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif
Here's the mold popped....I couldnt disconnect the mold from the foil/duct tape very easily but since blue painters tape is wussy as hell i was just able to pop it all off. Took a total of 2 minutes.
another...
and another....
And here's a picture of the sub ring i made while waiting for the fiberglass to dry... it's not superb but doesnt need to be if its goin under my carpet anwyay. Used a jigsaw to cut since i dont have that circle cutter tool for the dremel.
And lastly here's a picture of it in the trunk ready for some more layers
So anyways, project isnt goin too bad so far. Havent hit any problems except for the bubbles, and im hoping someone says its a good idea to dremel em off cause that wouldnt be hard at all i dont think.
What's the best type of fleece to use to cover my sub ring when i put it in place
Thanks for lookin.