I have 2 Kenwood 12s running at 4ohm 250w a piece on the stock radio, It was installed professionally by a company who has done installs on 3 of my cars and have always done a great job.
Anyways It will be running perfectly at one point and then just start to sound as if they are losing power, start to cut in and out, and eventually shut down and just kinda quietly hum. It is quite unpredictable when it will happen so it is hard to get it in the shop as its happening. I have had the wiring double checked it all looks great and the ground is solid, And I have run a volt meter on the car and it runs at 14.5 or so when running and around 12 when off. Any thoughts would be greatly appreciated.
Anyways It will be running perfectly at one point and then just start to sound as if they are losing power, start to cut in and out, and eventually shut down and just kinda quietly hum. It is quite unpredictable when it will happen so it is hard to get it in the shop as its happening. I have had the wiring double checked it all looks great and the ground is solid, And I have run a volt meter on the car and it runs at 14.5 or so when running and around 12 when off. Any thoughts would be greatly appreciated.