2 type r 1242d sub wiring

[^BBQ^ 10+ year member]

no one is i the official type r thread.



i want to wire my subs into 1ohm (parrallel parallel) and i was wondering if that is what it looks like? i just wanted to be sure.

Click to read more...

 

[bk12321 10+ year member]

http://www.crutchfieldadvisor.com/learningcenter/car/subwoofers_wiring.html?subs=2&impedance=DVC4x2

 

[^BBQ^ 10+ year member]

so bannana plugs - to - on each sub and + to + on each sub and then speaker wire to the outer - and + terminals?

 

[bk12321 10+ year member]

yes, going by the wiring diagram I would say u have it wrong

 

[^BBQ^ 10+ year member]

so what i said is right but not the picture?

the picture isnt mine i just wanted to give a visual to show everyone what im talkin about

 

[bk12321 10+ year member]

in the picture the + and - are hooked together, its supposed to be both +'s hooked together and both -'s hooked together, if u want a 1 ohm load

i believe in that picture they are wired in a 4 ohm load

 

[^BBQ^ 10+ year member]

thank you.

+1 street cred.

 

[Exploder 97 10+ year member]

yea,,, no need for plugs,,, just start from one sub,,, dual voice coil, start at one voice coil, postive to other postive on that voice coil,, same as negative... 1 sub done,,, now run the postive from the first sub over to the first postive on the 2 sub, then run the postive to the 2 voice coil. same as negative again, then on the last voice coil, run wires to your selected source

 

[grillman6000 10+ year member]

http://www.rockfordfosgate.com/rftech/woofer_wizard.asp