2 Ohm DVD on Mono Block, Quick Question

[cas0586]

(Again I butchered the title and cannot edit it.. DVD //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif !)

I have Cadence A7+HC and a SoundQubed HDS312. I want to verify so I have it wired properly

The amplifier has two speaker outs. Each pair is labeled 2 Ohms. Then each outside terminal is used for 1 ohm.

Like this:

[*][*][*][*]- Terminals

[2][2][2][2] - 2 ohm each pair

[1][X][X][1] - 1 ohm to outside terminals.

I can't take each sub +/- to each amp +/- for the amp to see a 1 ohm load or do I have to set it up like this:

Click to read more...

 

[ThatChevyGuy 5,000+ posts]

You can, but i would parallel the sub for 1 ohm as pictured.

 

[cas0586]

So, it sees 1 ohm either way? or only sees 2 ohm load if not like pictured.

Not sure how to get two 10 ga wires in one sub terminal to do it as pictured.

 

[dagormz]

So, it sees 1 ohm either way? or only sees 2 ohm load if not like pictured.
Not sure how to get two 10 ga wires in one sub terminal to do it as pictured.

It's not very hard. If they don't twist together to be small enough just trim some copper and try again.