2 12s

[frogcase2002 10+ year member]

if i got an ap3000 how should i wire it to 2 ssa zcons dual 2 ohm subs, going to get 2 if i get the first but wanting to no how i should wire them after i just get one, a pic or diagram would be helpfull, let me no

Click to read more...

 

[dappa5 10+ year member]

well you have three options

parallel /series/ mono ................ series / parallel/ mono................... parallel/ stereo

option #1 parallel /series/ mono

both subs 2[FONT=&amp]Ω + 2[/FONT][FONT=&amp]Ω wired down to 1[/FONT][FONT=&amp]Ω (pos 2 pos / neg 2 neg) then wire pos off sub #1 and neg of sub #2 to amplifier , this leaves you with neg(sub #1) and pos (sub #2) connect these two wires together //// you now have a 2[/FONT][FONT=&amp]Ω final load /// using the terminals marked ""bridged"[/FONT]

[FONT=&amp] [/FONT]

[FONT=&amp] [/FONT]

[FONT=&amp]option #2 [/FONT]series / parallel/ mono

both subs 2[FONT=&amp]Ω[/FONT] + 2[FONT=&amp]Ω[/FONT] wired up to 4[FONT=&amp]Ω[/FONT] (jumper between coil#1pos and coil #2 neg ) coil #1 neg and coil#2 pos out to amp ......connect both subs to the amp using the terminals marked "bridged" ////// [FONT=&amp]you now have a 2[/FONT][FONT=&amp]Ω final load[/FONT]

[FONT=&amp] [/FONT]

[FONT=&amp]option #3 parallel/ stereo [/FONT]

both subs 2[FONT=&amp]Ω + 2[/FONT][FONT=&amp]Ω wired down to 1[/FONT][FONT=&amp]Ω (pos 2 pos / neg 2 neg) then wire pos & negoff sub #1 and the pos & neg of sub #2 to amplifier, but this time hook the subs to each ch of amp 1 left and 1 right [/FONT]

[FONT=&amp]you now have a 1 [/FONT][FONT=&amp]Ω load X2 [/FONT]

[FONT=&amp]good luck lmk if you need a diagram or something [/FONT]

[FONT=&amp] [/FONT]