10 speaker wiring help please!!!

  • 1
    Participant count
  • Participant list

norrizzle90
10+ year member

Cant lose with 22's
i have 10 8 ohm speakers going into a pa system in a warehouse. what would the wiring look like to get them wired down to 4 ohms? there is also a 8 ohm option on the amp, what would that wiring look like? thanks in advance guys. //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I agree with every one above. OFC is much better. Copper is a much better conductor than aluminum.
6
618
Parallel at the amp is the same as parallel at the speaker then to the amp. Just like parallel off of a single subwoofer driver with two voice...
2
1K
appriecate it man! I was so busy thinking about it that I didn't even think I could look it up with a multimeter.
5
2K
Lower impedance does not burn up speakers...too much power or a distorted signal are what smokes a coil...
12
1K

About this thread

norrizzle90

10+ year member
Cant lose with 22's
Thread starter
norrizzle90
Joined
Location
detroit, MI
Start date
Participants
Who Replied
Replies
0
Views
381
Last reply date
Last reply from
norrizzle90
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top