1 ohm or 2 ohm

[manosteel916 10+ year member]

what companies would you guys consider to be good amp manufactures

 

[PESteele 10+ year member]

http://www.caraudio.com/forum/showthread.php?t=97618&highlight=good+companies

 

[Beat_Dominator 5,000+ posts]

Sinfoni. //content.invisioncic.com/y282845/emoticons/tongue.gif.6130eb82179565f6db8d26d6001dcd24.gif

Diamond, Eclipse, Orion, Kicker, JL, RF seems top work, Sound Stream, older PPI, etc...

 

[PESteele 10+ year member]

dei also

 

[manosteel916 10+ year member]

what would you say about soundstream under rated or over rated inpinticular the pca2000

 

[Beat_Dominator 5,000+ posts]

Probably pretty close to rated. Not much over/under.

 

[XaznKewLguyX 10+ year member]

was wondering the same question. I have a US Amps MD2 its rated 1000x1 @ 2 ohms and 1500 x1 @ 1 ohm. I am goign to buy 2 12" RL-P's. Which one should I buy d2 or d4? If i wire both of them to 2 ohms I will get rougly 500w per sub and if i wire by 1 ohm i can probably get 750ish each sub. Which would be better? This is for a daily driver so I need to know if im damaging or risking anything.

Sorry OP if I am thread jacking.//content.invisioncic.com/y282845/emoticons/blush.gif.99bc659ee2012b7d826165e26fb5eebe.gif

 

[manosteel916 10+ year member]

was wondering the same question. I have a US Amps MD2 its rated 1000x1 @ 2 ohms and 1500 x1 @ 1 ohm. I am goign to buy 2 12" RL-P's. Which one should I buy d2 or d4? If i wire both of them to 2 ohms I will get rougly 500w per sub and if i wire by 1 ohm i can probably get 750ish each sub. Which would be better? This is for a daily driver so I need to know if im damaging or risking anything.
Sorry OP if I am thread jacking.//content.invisioncic.com/y282845/emoticons/blush.gif.99bc659ee2012b7d826165e26fb5eebe.gif

from what i understand i'd do the dual 2 ohms cause you realy wont hear the difference of distortion between the two configurations . youll just get a little louder with the extra 250 going to each rl-s

 

[helotaxi 5,000+ posts]

from what i understand i'd do the dual 2 ohms cause you realy wont hear the difference of distortion between the two configurations . youll just get a little louder with the extra 250 going to each rl-s

You need the dual 4 to get that 1 ohm load. Dual 2 won't do it.