protection mode

Hi Guys, I just bought this Audison lrx 2.9 amplifier. The amp is wired correctly. Trying to run JBL 1220D (2ohms per coil) . Connected the positive to speaker left positive and negative to speaker right negative. Ground is connected to NEGATIVE and Battery to POSITIVE. Switched between mono...

So I’m having a issue with my amp going into protection mode after turning the radio up, it’s a stock bmw radio and the positive and ground are 11.90 when cars off and 13.60 when car is on, I switched amp snd still did the same thing... don’t know what else to check. Do if anyone can Help me out...

So I’m having a issue with my amp going into protection mode after turning the radio up, it’s a stock bmw radio and the positive and ground are 11.90 when cars off and 13.60 when car is on, I switched amp snd still did the same thing... don’t know what else to check. Do if anyone can Help me...

I recently bought a 2013 lesus gs350. Transfered everything from my old car.  Pioneer GM D9601 kicker 10cvx12 compvx 4ohm some boss cap 10farads  dont remeber specific model but it worked fine in old car. everything worked fine in old car Set everything up in new car. Wire up the lc2i. Lc2i...

Hi guys. I have a kicker L7 powered by a kicker lx 600.1. Although the amp still runs, the protection light stays on and the amp sometimes starts smoking. I unplugged everything and tried it in another car with professional wiring etc and it happened again. I have opened up the amp and can see...

OK so I had a little 400 watt crappy duel amp hooked up to 2 10 inch mtxs but then i bought a 12 inch kicker comp and a Audiobahn A8000t its a 1600 watt mono maxx amp. Ok now here is the issue i have all the wiring done right in my bmw and it was running my old amp and subs now when i hook up...

Hello, i would like to just say right off of the bat.. i know a little but not nearly enough to diagnose this situation, so bear with me while i try to explain it the best that i can. So here it is: I have an mrv-f300 alpine amp (literally brand new, exchanged under MFG warrenty today, but...

So today my almost brand new kenwood excelon x500-1 went into protection mode. After checking the ground, fuses and unplugging all wires except for the power and ground the problem still proceeded. I went and bought a brand new kicker dx1000.1 and the same thing is still happening? Does any one...

Ok I replaced my head unit to a sony explode, added a sealed battery, and ran 4 awg power wire from the front to the beck and a foot long 4 awg ground for the second. I still have te problem of my amp going into protection mode. I bought a volt metter and my car off it reads around 12.30ish car...