Featured Concord C2050 2-1 Channel Amp Info

spokey9 said:

I pulled the stock head unit and used a single din kit to put in an aftermarket. The kit was like $20

To get it out you have to pull that center piece out it's like 4 screws and a couple clips holding it in

Click to expand...

CertifiedHoodClassic said:

It's also possible you could sell that 90's amp to a collector and buy a newer one that's better in every way with the money, one of the oldheads here would have to tell you about the value of it

Click to expand...

spokey9 said:

Np buddy. Honestly the biggest issue I had doing my saturn was the clearance in the doors in the factory speaker locations. Takes a low pro to wedge in there

Click to expand...

spokey9 said:

The stock speakers won't take power well

Click to expand...

Doxquzme said:

The amplifier is 2x50 watts at 4 ohms and 2x65 at 2 ohms. Any decent 16-148 gauge wire should be more than adequate, 16-14 for power if you can squeeze it in.

Something like these:

Amazon.com

Find the right one, get creative, and wire up some 12-gauge copper wire for the +/- and use 16-18 for the remote and speakers.

Click to expand...

Doxquzme said:

Try searching for the male MC04M molex jrn003 4-pin (?), or the inserts that go into it, then solder or crimp to the pins, and insert them accordingly.

Click to expand...

Doxquzme said:

Not sure why you would want to do that. Any good quality 16-gauge wire should suffice (up to about 100').

Click to expand...