Recent content by phogstenjr

  1. P

    Alpine Amps

    hello, I have an Alpine MDR-M501 pushing 2 - 12" Orion C2 subwoofers. Paul
  2. P

    Zed Audio Gladius with or with out Burr Brown chipset

    Yep, I purchased the 12" enclosure at the Harper Woods Circuit City store. So far this enclosure with the Orion subwoofers sound great (have played for about an hour tonight). I supose they will sound better when they are broke in. I will also have to fine tune all the amplier setting on this...
  3. P

    Zed Audio Gladius with or with out Burr Brown chipset

    Hello, Today I am installing my old Alpine MRD –M501 subwoofer amplifier. I sold my old subwoofer box (2 - 10" Power Acoustik FUBR Series). I purchased the following since I am on a budget (total cost for the subwoofer and enclosure under $115.00: 2 - Orion C2 124 ($29.00 each at Mickey...
  4. P

    Zed Audio Gladius with or with out Burr Brown chipset

    Hello, I just installed my old set of Quart Mobile 218.03 CX in my 2006 Civic LX Sedan and am currently running them on the head unit's (Kenwood DPX301) internal amplifier (rated at 22 watts X 4 at less than 1% THD). I am considering the Zed Audio Gladius amplifier to run the QM 218.03. Can...
  5. P

    Crimping vs. Solder

    I think soldering is the way to go from the sandpoint that if done correctly there is no chance for the wire to come apart. Nothing worse than a two wires coming a part because of a bad crimp. Paul
  6. P

    boxing speakers NOT SUBS

    Hi, I am also considering this, (i.e., building an enclosure for rear speakers). I imagine that a subwoofer (2 – 12’s) located in the trunk will cause problems with the speakers mounted in the rear deck (infinite baffle). Any thoughts? Paul
  7. P

    Optima Yellow Top, worth it?

    How do you think the D51 Optima Yellow top will hold up? I have a 2006 Civic and just checked out this battery at Sears ($150). Paul
  8. P

    How should I wire my subs -

    Thanks So the 2 - Orion C2 124 12 inch subwoofers that I now have, which I thought were dual 2 ohm voice coils, are (according to the Orions website) actually 2.8 ohm's. Depending on how I configure, my amp would see either a .7 ohm load or a 2.8 ohm load correct? Paul
  9. P

    How should I wire my subs -

    2 - Orion C2 128 12 inch subwoofers have dual voice coils with a nominal impedance of 4 ohms each. If I run each subs voice coil in serial, each sub would see a 2 ohm load correct? Then if I run these to my amplifier parelell, I would get a 2 ohm load, correct? Thanks for your help, Paul
  10. P

    How should I wire my subs -

    Hello,   I purchased the following: 2 - Orion C2 124 12 inch subwoofers MTX Dual 12" Subwoofer Enclosure (BS212S) Alpine MRD-M501 Subwoofer amp (550 watts x 1 @ 2 ohmes)(225 watts x 1 @ 4 ohmes).   The box has two individual enclosed 1 cubc foot cavitys. Each having its own terminal for...
  11. P

    Best Sub Under $100

    I have a set of Orion C2 124 - 12" subwoofers. I picked them up loacally (Mickey Shorr) for $29.00 a pair (Total = $58.00 + tax). I picked up a 1 cubic foot MTX sub enclosure for these PCs for $49.00 at Circuit City. Not a bad price $110.00 for an enclosre with two 12" subwoofers.
Top