Recent content by nra424

I must have been in the laziest mood when it happened because when I disconnected the remote wire from the mono, the 4 channel finally turned off (with ignition off). So my question is, did I blow the fuse on the mono when I installed it? If I need to replace it, the amp has 4 20 amp fuses so...

hi i accidentally left the negative attached on the battery and connected the power wire to my mono and then when attaching the ground wire, it sparked. The amp wont turn on now. The 4 channel however is staying on even with the h/u off. Is my remote wire the problem?

I had a 4 channel alpine and a mono hifonics powered with 4 gauge split from 1 gauge through a distribution block. They both have 4 gauge grounds that meet at the same point on the chassis. The remote wire for the 4 channel alpine was stripped at a point and I attached another length of remote...

Well I set a dmm on ac-v and put the pos tip on the tip of one of the sub rca's coming from the hu and the neg tip on the surround of the rca. I heard this should cause some sort of reading on the dmm if its sending a signal? Please correct me if Im wrong, but anyways the dmm didnt respond so I...

Hey everybody, I recently bought a refurbed Hifonics 1206d bxi from an ebay seller with 99.1% feedback. I has just finished rerouting the wiring on my car and had installed the amp and was pleased to see the logo glow blue. Unfortunately, when I hooked up the re se12 im using, there was no...

Hey Im gonna run a single se12 at 2 ohms and was wondering if the 1206d is rated accurately enough for me to just go with that, or if I should go with the 1606 and be careful with the gain? Thanks

Im not planning on upgrading power at all so im just wondering if i can get away with 4 gauge. and also what size fuse?

Hey, just wondering what gauge wire would be safe to run from the battery to a distrib. block for a 750w mono and a 80x4? Thanks

how about swapping in a h/o alt like this...

Hey ive got a recently restored, 1975 BMW 2002. After replacing the speakers and installing a new 4 channel amp, I'm looking to install this RE SE12 that's sitting in my room. What would I need to do to maintain healthy voltage? Im afraid the alternator is probably pretty lame... Thanks

I went out to try to reset the gain on my 4 channel alpine for my 4 coaxial speakers. I set the gain all the way down and when I turned the stereo on, it would play and then there would be randomly timed loud popping/distortion sounds. The volume was on low, but the distortion was super loud...

Thread hi-hi-hi-hi-hi-JACK! Is 16 gauge too small for a sub getting 800 watts?

Thanks a lot guys. I was also kinda wondering if there was anyone who could help me or point me in the right direction with designing the box. I was thinking the recommended 1.5 at 34 hz. I just dont know how to calculate/tune the frequency

Sorry for such a dull thread but... I drive a '75 bmw 2002 and just got a se12. I don't have any experience building boxes but already have my sealed enclosure figured out (impressive i know!). Im obviously not gonna lose any sleep about not being too loud but I atleast want to be able to...

hey ive got a really tiny bmw coupe and only i'm trying to keep some trunk space. i was wondering if a single sealed se 12 with 600-700 watts would be loud enough for a daily driver setting. the reason im drawn to the se is the price and im lookin for sq. im just lookin for something that can...