Recent content by Lube

Tried that, volume changes but no audio

But they can hear me through the built in microphone. I have a Pioneer x5800BHS in my 2005 Chrysler 300C. It does it on any phone connected to the stereo... Playing music from youtube to to the stereo via bluetooth is fine, but as soon as I answer a phone call from bluetooth, I can't hear...

Shouldn't... AFAIK the system has no factory amplifiers.. but I ordered a different harness that has a remote wire on it so we'll see..

bump..........

Also... no factory amp. 6 speaker system Its all wired correct!!! UGH!

so after wiring it all up correctly... their is no sound playing at all!! The stereo turns on and is fully functional but their is absolutely no sound. What could be my issue? Info: Stereo: JVC- KW-AV61BT Harness: PAC C2R-CHYNA Car: 2005 Chrysler 300C with REF stereo EDIT: The harness...

I might upgrade the battery but it should be okay. It is brand new afterall. Superstart premium 34/78. I will look into an Optima redtop or diehard platinum for later use. Well, stock wires go to the side posts. Big 3 + amp is on the top posts. Same locations as the stock wires for grounding...

Actually my alternator is stock. But if I can find someone with that, It'd be very helpful.

It hasn't been dropping too bad now (I haven't touched anything) but when I have my lights on my voltage will be at 13 volts and go down to 12.6 when hard bass hits

Sorry, - 96 Cadillac Eldorado - JVC KW-AV61BT Deck - 4 Gauge power & ground - Stock Bose 4" front and 6x9 rear - 2 Pioneer 12" TS-W309D4 - Pioneer Amp GM-D8601 Tomorrow I will remove the grounds and re-sand. I don't have room in my trunk for a 2nd battery. I listen to rap. iTunes...

triple checked, all ok

I just put in a new alternator. 140 amp 800 Watts rms ran with 4 gauge wire 1/0 gauge big 3 done. It's fine driving at around 13.4 with heavy bass hits but as soon as i idle it'll go down to 12.7 Would adding my capacitor back in help? 500k Scosche cap. Or do I need a bigger cap...

If homemade really should be done, what do I need & what program can help me? Here are both my subs: TS-W309D4 - 12" Champion Series Subwoofer with Dual 4 © Voice Coil | Pioneer Electronics USA Currently have them in a ****** sealed enclosure...

So $300. I need: (2) Front 4" speakers (5 1/4" are considered so feel free to suggest those, I gotta make sure they fit) (2) Rear 6 x 9 speakers (1) 4-Channel amplifier to drive them (1) 8 gauge wiring kit for amp (with 4 channel RCA if possible, & speaker wire) for application...

Yes it does. Pounding bass. I'll find one around lol thanks though