Recent content by DRMVP21

Thats not what I said. I said that 4 12's will have a flatter response and be just as loud as the 2 ported. I have 2 12's ported and while it does get as loud or louder then 4 12's the 4 have a better high frequency response and will be a lil louder under 30hz

um not really cause even though 2 12's ported may get just as loud or louder then 4 12's between 30 to 50 hz the four 12's will have more usable bass output below and above that range. So if u have a big car with a lot of space the 4 12's will blend better with ure front stage and get lower then...

For the kicker amp that runs at 2ohms you want the DVC 4ohm. If you wire it in parallel you will give the amp a 2ohm load which will get the most power out of that particular amp. If you go with an amp that can go down to 1ohm then you want the DVC 2ohm. If you wire that in parallel you will...

Thats really not bad. That amp is worth about that new. Its really underrated. I bet that thing puts out 1800wrms. A little pricey but mtx amps are very nice.

that amp cost more then other amps in the same range because they are underrated...

the 4 10's ported should be considerably louder and sound just as good.

What is your price range range? The reason i ask, is because it will cost you a good amount to get a class/ a/b amp that will push that much power, also a class a/b amp of that power will be huge. Just get a good class d and call it a day. It will save you money, you will get more power, and the...

Yea it should be good for the pair. I would just make sure that you are not overdriving it with one sub because it will take less power to reach full excursion.

I would just tune a lil higher, really no reason to tune so low. I would go for 32 hz and it should get a lil louder. I would also put more power to them. If thats not loud enough, time to upgrade. How about some 3004spls? The 12's will get plently loud and low off of 1400 watts! If you can get...

You are an idiot. So if i hook up a dmm to my amp and it reads say like 30 volts which is 900wrms that i could still be clipping jus cause bb is on. You are an idiot.

^^^

^^^ stfu. Why am i gonna go and buy a unit with better preouts? As long as it is not clipping and not overheating the amp will be fine. What do you do if you can't get desired voltage without BB? Buy a new headunit or turn up the BB until the desired voltage is reached. If used BB on multiple...

You tell me how? I have the pioneer 2v preout and with the gains maxed it still takes about 6db of bass boost to get the desired voltage and it was measured using a dmm. So who's the idiot now? If you have weak preouts sometimes u have to bass boost especially to get power out of hifonics amps...

3ft^3 @ 32hz FTW!

Yea they are really punchy and can still get pretty loud sealed. Just give them atleast 1500wrms.