My headunit outputs a low level balanced signal but it is over 2 wires not 3 (there is no ground reference) but my DSP cannot accept a balanced signal. I’ve looked at converters online but the inputs all seem to be XLR connectors, which are 3 wire. How would i go about this??
-
1Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
As for a coned speakers (woof, midbass, mid) driver polarity, a common household D cell battery works great. Connect the batter to wires, touch...
- Started by Kickstand
- Wiring, Electrical & Installation
Sounds like you shorted the other channel so check you connections. Don't ask just look. Will solve your problem Every time. If you ever short out...
- Started by NikoFrancs
- Subwoofers
You just found your own solution. Move the DSP elsewhere. The RCA is triple protected but not the RCA plugs. I do not know if there is a mesh or...
- Started by edikecske
- Wiring, Electrical & Installation
u may be referring to the yellow wire and red wire. But there's a voltage drop just at the on position. So no signals come in via antenna. Or...
- Started by willkel04
- General Car Audio
I have it set to "best available"
- Started by ender2664
- General Car Audio
About this thread
