I'm new to the forum and thanks for your help. I'm installing a stereo in my boat and had a question about the wiring of this JL Audio 6450 amplifier. I'm not clear if my diagram puts a 2 ohm load in channels 1,2, & 3 or a 1 ohm load (see attached diagram). Amplifier is 2 ohm stable. Thank you very much for any help you can give me. If you need additional information please let me know and I'll do my best to provide it.
if the voice coils are 4 ohms on your speakers then you have the two ohm load you are looking for.
- Thread Starter
- #4
It is a single 4 ohm on the sub. Thank you for the quick replies, I really appreciate the help.
Activity
No one is currently typing a reply...
Similar threads
I agree with every one above. OFC is much better. Copper is a much better conductor than aluminum.
- Started by kanihoncho
- Wiring, Electrical & Installation
In a case like
In a case like yours I would rather recommend tactile transducers. They are like woofers without the cone section that are...
- Started by timbo2410
- Subwoofers
I have a jeep wrangler 2010 4 door.. So 2 of my speakers are in the dash upfront. And the other 2 are in the bar in the middle of the car
Do you own a DMM(digital Multi Meter) at all?
- Started by WhereMyExWifeAt?
- Wiring, Electrical & Installation
For clarity, why not example 2 ?
Example 2 is 2 ohm...my speakers are 4 ohm and amp uses less RMS wattage with the bridged 4 ohm full range...
- Started by Tynan9180
- Wiring, Electrical & Installation
About this thread
