Recone through FI?

it's right there on the website

it's right there on the website

Click to expand...

Fi has a website?

(lol I knew someone was gona say "Fi has a website?")

I did mine myself, Its actually pretty easy to do. Just nerve racking you might screw up.

heres a decent instructional type video that shows steps on how to do it.



Dont use epoxy, do it right and get some IC-2000 Ca glue and some ca glue accelerator

IC-2000 Rubber Toughened CA (hlc117) Hobbylinc Glue Cyanoacrylate (Instant Glue)

Go easy on the accelerator spray or it will start to look nasty.

it's right there on the website

Click to expand...

Fi does not have a website //content.invisioncic.com/y282845/emoticons/fyi.gif.9f1f679348da7204ce960cfc74bca8e0.gif

Ficaraudio.com

Ficaraudio.com

Click to expand...

lies that sites a fake

So dumb question . is it possible to change the ohm load by reconeing? I ask because my subs are d2s and i would like to make them d4s

So dumb question . is it possible to change the ohm load by reconeing? I ask because my subs are d2s and i would like to make them d4s

Click to expand...

lawl no you need to get new motors

I thought so but just wanted to check.

I thought so but just wanted to check.

Click to expand...

He's fucking with you. The speaker impedance is dictated by the voice coil. The voice coil is replaced when doing a full recone.

This is why you always call them first, instead of just coming here.