Recone through FI?

[Maxipads 10+ year member]

How do i get one? lol like do i make an appointment or do i fill out a form with my sub and send it in? I'm not quite sure how to do it.. I need to make it a D1 so i can run two of them.

Click to read more...

 

[treasony 10+ year member]

it's right there on the website

 

[RAM_Designs 5,000+ posts]

it's right there on the website

Fi has a website?

 

[Maxipads 10+ year member]

I know but do i ship them my sub then? i don't know how to drop a recone in.

 

[treasony 10+ year member]

(lol I knew someone was gona say "Fi has a website?")

I did mine myself, Its actually pretty easy to do. Just nerve racking you might screw up.

heres a decent instructional type video that shows steps on how to do it.



Dont use epoxy, do it right and get some IC-2000 Ca glue and some ca glue accelerator

IC-2000 Rubber Toughened CA (hlc117) Hobbylinc Glue Cyanoacrylate (Instant Glue)

Go easy on the accelerator spray or it will start to look nasty.

 

[Buck 5,000+ posts]

it's right there on the website

Fi does not have a website //content.invisioncic.com/y282845/emoticons/fyi.gif.9f1f679348da7204ce960cfc74bca8e0.gif

 

[corrie32 10+ year member]

Ficaraudio.com

 

[Toone 10+ year member]

Ficaraudio.com

lies that sites a fake

 

[quins90lac 10+ year member]

So dumb question . is it possible to change the ohm load by reconeing? I ask because my subs are d2s and i would like to make them d4s

 

[hatedonmostly 5,000+ posts]

So dumb question . is it possible to change the ohm load by reconeing? I ask because my subs are d2s and i would like to make them d4s

lawl no you need to get new motors

 

[quins90lac 10+ year member]

I thought so but just wanted to check.

 

[audioholic 5,000+ posts]

I thought so but just wanted to check.

He's fucking with you. The speaker impedance is dictated by the voice coil. The voice coil is replaced when doing a full recone.

This is why you always call them first, instead of just coming here.