Z71 extended cab

[camaroaudio69 10+ year member]

Well i sold the camaro and gotthis now so im switchin up the system. Im pretty much set amp wise with the sundown 1000d now its just the subs. Im going to either run two 12s or 4 10s I basically can spend up to around 400-450 for subs im looking for a good daily driving system that gets pretty low. Just wanted to see some ideas on subs. Right now i was thinking about L7s CVxs or some dc level 2s any other ideas?

Click to read more...

 

[blackbonnie 5,000+ posts]

are you taking out the back seat or keeping it?

 

[redfish8]

sent you a pm camaroaudio

 

[ProgMtl 10+ year member]

Going to be tough getting (4) 10's in there with the proper airspace if you're leaving the seat intact.

 

[blackbonnie 5,000+ posts]

its not possible with the seat in there. even if you raise the seat 2-3 inches, you still wont get them the proper air space. well depending on what subs but it will still be hard. im working on a design for my 06 silverado right now

 

[zierbox 10+ year member]

 

[blackbonnie 5,000+ posts]

has the seat been rasied? and also you can see the subs hitting the seat, its a good design. what is the volume of the enclosure though?

 

[zierbox 10+ year member]

The seat has not been raised

The bottom of those seats have no structure under them only loose hanging carpet (you can make the height of the box lower if needed

Don’t remember the volume at the moment (plenty of room), however I only build boxes that work

 

[blackbonnie 5,000+ posts]

what year truck is that? and are those tens?

 

[Kold_Killa 10+ year member]

Have you never had a problem with the subs hitting the bottom of the seat like that?? Especially with someone sitting in the seat??

 

[camaroaudio69 10+ year member]

i still wanted to leave the seat in i like that box with the mtxs

 

[Ignatowski 5,000+ posts]

rasied seat2",single 12Q,2.5CF.....box built exceptionally well by

Phil over at woodlawn cabinetry....

 

[ProgMtl 10+ year member]

No offense but that looks pretty bad with the box protruding out that far from under the seat...you must never have any passengers back there? Not to mention it doesn't look like the seat goes all the way down to it's locking position.

 

[Ignatowski 5,000+ posts]

No offense but that looks pretty bad with the box protruding out that far from under the seat...you must never have any passengers back there? Not to mention it doesn't look like the seat goes all the way down to it's locking position.

I never have passengers and the seat has since settled down a bit....All in the name of BUMP

 

[ProgMtl 10+ year member]

I've always been extremely pissed as to why Chevy didn't put the mounting bracket on the rear passenger side on the floor also...it's in the way up on the back shelf...idiots!