Wtf Is Wrong!!

what gauge wire are u running. Make sure ur Subs ohm load is wired correctly. Make sure everything is connected properly and make sure ur inline fuse isnt blown or any other fuses on the amp.

 
Genearlly an amp will not go into protection with a to high gauge of wire. 10 Gauge is enough to turn it on and keep it on.

MY main feeling is that your subs are not wired correctly.

I would wire it up to 4 ohms. Test, then down to 2 and test.

 
Genearlly an amp will not go into protection with a to high gauge of wire. 10 Gauge is enough to turn it on and keep it on.MY main feeling is that your subs are not wired correctly.

I would wire it up to 4 ohms. Test, then down to 2 and test.

i agree. power wire wouldn't make an amp go into protection mode i believe. it might make the amp produce less power than expected but not in protection mode.

check how you wired ur subs again, and check your ground, make sure it's a nice clean connection.

 
man u guys dont understand i fuxed up my amp cua the power wire was to small..

so it might not go into protection, but could still mess it up..

cuz mine neva did..

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Kicker4Life

10+ year member
Junior Member
Thread starter
Kicker4Life
Joined
Location
Diboll, TX
Start date
Participants
Who Replied
Replies
7
Views
867
Last reply date
Last reply from
djjdnap
1778763859842.png

Doxquzme

    May 14, 2026
  • 0
  • 0
IMG_20260513_214311575.jpg

ThxOne

    May 13, 2026
  • 0
  • 0

New threads

Top